| Specifications |
|---|
| Capacities | NSF Rated Capacity: |
| Motor Horsepower | Wash |
| Water Consumption | Gal per rack: |
| Temperatures | ADC-44 |
| Heating | Wash |
| Sanitizer | ADC-66 |
| Utilities |
|---|
| Utilities & Other Notes |
| Power Supply |
| 208/240V, 3 PH, 60 AMP, 60 HZ |
| 3 Phase installation requires 6 gauge wires, a suitable ground, and a clean 60 amp circuit. |
| 1 PH, 50/60 AMP, 60 HZ |
| 1 Phase installation requires one (1) 50 Amp service using 8 gauge wires with a 10 gauge neutral wire, and one (1) 60 Amp service using 6 gauge wires and a suitable ground, both on clean circuits. |
| Other Notes |
| Both clean and soiled tables are to be bolted to the dishmachine with the 1/4-20×1/2″ bolts and nuts provided. |
| Leaks cause potential problems in electrical and mechanical areas under the machine. |
| Quick drains (table scuppers) are not compatible with stage type conveyor dishmachines. |
| Scrap sinks shall be no closer than 20″ minimum from the dishmachine end of table. |
| The clean exit table should be at least 72″ straight for efficient conveyor operation. |
| Electrical and plumbing connects should be made by a qualified service person who will comply with all appropriate state and local health, electrical, plumbing, and safety codes. |
| *Manufacturer reserves the right to modify these specifications in compliance with regulatory agencies and manufacturing expediency. |
| Downloads |
|---|
| Brochure |
| Brochure |
| Wire Diagram Adc44 3Ph |
| Wire Diagram Adc44 3Ph Side Loader |
| Wire Diagram Adc44 1Ph Neutral |
| Manual |
| Manual |
| Design Conveyor Top Mount Booster |
| Manual |
| Parts Manual |
| Adc44 1Ph Neutral Ladder Chart 2023 Pdf |
| Adc44 3Ph Ladder Chart 2012 Pdf |
| Manual |
| Spec Sheet |
| Brochure |
| Parts Manual |
| Manual |
| Parts Manual |
| Conveyor Vent Attachments Pdf |
| Hood Fan Control Pdf |
